Description
Smart relay with energy metering for switching two circuits
The two-channel Shelly Wave 2PM smart relay with energy metering switches two independent loads over a Z-Wave network, such as lights, ceiling fans or infrared heaters. Each channel carries up to 10 A, both together up to 16 A, and in AC circuits the relay measures each channel’s energy use separately.

A smart relay hidden in the wall box switches loads on smart home commands
A smart relay is a module fitted in a wall box or on a DIN rail in the consumer unit that switches a light or appliance by phone, schedule or smart home command. The Shelly Wave 2PM fits a wall box with its 37 × 42 × 16 mm housing and works with your existing switch or push-button.

Operating modes and protection
By default the relay works with an ordinary switch, and a push-button can be selected in the settings. In detached mode the outputs are controlled only from the hub app. After a power cut the relay restores the output state according to the chosen setting. It switches resistive, capacitive and inductive loads with an RC snubber.
Overheat, overcurrent and overvoltage protection trips when the temperature exceeds 80 °C, a channel current exceeds 10 A by more than 10% or the voltage rises above 278 V for 5 seconds.

Z-Wave Long Range and smart home platforms
In a mesh network, where devices pass on each other’s signal, the relay uses 868.4 MHz, reaches up to 40 m indoors and acts as a repeater itself. In Z-Wave Long Range mode it works at 864 MHz and connects directly to the hub from up to 80 m indoors or up to 1000 m outdoors. The relay works with Home Assistant, SmartThings and Homey and with all certified Z-Wave Plus hubs.
Setup and app control need a Z-Wave hub. SmartStart adds the relay to the network by scanning a QR code, and S2 security protects the communication. Firmware updates reach the relay over the air (OTA).

Installation and wiring
The relay runs on 110–240 V AC or 24 V DC and also works in DC circuits, where it switches up to 30 V and 10 A. The terminals take 0.5–1.5 mm² wire stripped to 5–6 mm, with a terminal screw torque of up to 0.4 Nm. Operating temperature is −20 to 40 °C at 30–70% relative humidity. Factory settings are restored with the module’s S button.
In the box
- Smart relay Shelly Wave 2PM, 1 pc
- User guide, 1 pc

Reviews
There are no reviews yet.