Description
BLANCO ANDANO 340/180-U undermount stainless steel sink
The undermount stainless steel sink BLANCO ANDANO 340/180-U is fixed from below into the worktop cut-out, and its edge rests against the underside of the worktop. The sink has two bowls side by side: a large bowl on the right and a narrow small bowl on the left. The surface has a satin finish (satin polish), and the outer dimensions are 585 × 440 mm with a height of 199 mm.
Installation under the worktop
A dense and waterproof material is suitable for the worktop: natural stone, composite or glass. Wood and wood-based board are not suitable for this type of installation. The worktop cut-out measures 545 × 400 mm, with a permitted tolerance of +2/−1 mm and a corner radius of 22 mm.
Six fixing points are drilled into the underside of the worktop 27 mm from the edge of the cut-out: the hole diameter is 5 mm and the depth is 13 mm. Before sealing, the edge of the sink is cleaned with isopropanol, then silicone is applied to the edge, the sink is pressed against the worktop from below and fixed with the screws from the fixing kit, which are tightened with a PZ 2 bit. After removing the excess silicone, wait 24 hours before use.
The mixer tap is installed in the worktop: a 35 mm hole is drilled 60 mm from the edge of the cut-out. The waste outlet is 290 mm below the top surface of the worktop. The dishwasher is connected with a separately sold trap.
Bowls, waste and overflow
The bottom of both bowls has a 3½-inch InFino basket strainer, which is opened and closed by hand. The waste of the small bowl connects to the waste pipe of the large bowl, so the sink needs only one trap. At the back wall of the bowls there is a covered C-overflow, which is part of the InFino waste system. The waste pipe in the set is space-saving: the pipe is routed towards the back wall of the cabinet, leaving more room under the sink, which is why BLANCO recommends it together with a pull-out waste separation bin.
Stainless steel and surface finish
The sink is made of 18/10 stainless steel, which contains 18% chromium and 10% nickel. Together with oxygen, the chromium forms a thin and invisible protective layer that restores itself. Fine scratches that appear on a new sink in the first weeks are normal, and as the protective layer restores itself they become less noticeable within a few days.
The satin finish is the finest surface of BLANCO stainless steel sinks, with a warm undertone. A hot pot or long sunshine does not change the tone of the surface. If reddish spots appear on the surface, they are particles carried over from other rusting objects or from water pipes, and they wipe off.
Stainless steel sink care
For everyday cleaning, put a little washing-up liquid on the soft side of a sponge and wipe in the direction of the brushing, because circular movements change the structure of the satin-finish surface. Then rinse the sink and dry it with a microfibre cloth. To remove limescale, use vinegar essence diluted with water at a ratio of 1:10, or a limescale remover.
Once a month, clean the sink thoroughly with a stainless steel cleaner: apply an amount the size of a hazelnut to a sponge and rub the surface in the direction of the brushing. To clean the basket strainers, put a level teaspoon of dishwasher powder on the closed basket strainer, pour about 250 ml of boiling water over it, let it work, brush clean and rinse. Do not use abrasive cleaners, bleach containing hypochlorite, silver cleaning baths, the rough side of a sponge, metal scourers, products containing chlorine or hydrochloric acid, or a strong salt solution left to act for a long time.
Included
- BLANCO ANDANO 340/180-U kitchen sink, 1 pcs
- Waste and overflow set with space-saving pipe
- 3½″ InFino basket strainer, 2 pcs
- Fixing kit
Required separately
One trap is needed to connect the sink to the drain. The BLANCO 137267 kitchen sink trap connects the waste set to a Ø40 or Ø50 mm drain pipe and has a dishwasher connection. If a waste separation bin is to be placed under the sink, the flat BLANCO 137287 kitchen sink trap is suitable, with a Ø50 mm outlet and a connection for two appliances. The kitchen mixer tap must also be bought separately.






Reviews
There are no reviews yet.