Description
Undermount stainless steel kitchen sink with two bowls
The undermount stainless steel sink BLANCO ANDANO 340/340-U is fixed from below into the worktop cut-out, so that the edge of the sink stays under the worktop. The sink has two bowls of equal size side by side. The surface of the sink has a satin finish (satin polish), which gives the stainless steel a silky sheen.
The outer size is 745 × 440 mm and the height is 199 mm. The corners and bottom edges of the bowls are rounded, and the flat bottom can be used over its full extent.
Installation under the worktop
The sink is suitable for a dense and uniform worktop, for example natural stone, composite or glass. Wood and wood-based boards are not suitable for an undermount sink. The size of the opening to be cut in the worktop is 705 × 400 mm, the permitted tolerance is +2/−1 mm and the corner radius is 22 mm.
For screw fixing, the worktop must be at least 18 mm thick, and the holes for the fixing screws are drilled with a 5 mm diameter and a depth of 13 mm. On a thinner worktop, which is at least 10 mm thick, the sink is fixed with the separately sold set 244 755, whose fixing pins are glued to the worktop with epoxy glue. The mixer tap is installed in the worktop: the diameter of the hole is 35 mm and it is drilled 60 mm from the edge of the cut-out.
Before installing the sink, the surface of the worktop to be glued is cleaned with isopropanol and the edge of the sink is sealed with silicone. After sealing, you must wait 24 hours before use. According to the installation drawing, the drain pipe sits 290 mm below the top surface of the worktop.
Bowl, drain and overflow
The drain of each bowl has a 3½″ InFino basket strainer, which is opened and closed by hand. The overflow is covered by a C-overflow, which stays hidden in the shape of the bowl. The space-saving pipe of the drain set leads the water towards the back of the cabinet and leaves more room under the sink.
BLANCO recommends such a pipe if a pull-out waste sorting bin is to be fitted in the sink cabinet. The dishwasher is connected to the waste trap.
Stainless steel and surface finish
The sink is made of 18/10 stainless steel, which contains 18% chromium and 10% nickel. Together with oxygen, chromium forms a thin invisible protective layer on the surface, which renews itself. The first fine scratches on a new sink are normal and become less noticeable over time as the protective layer renews itself.
The satin finish is the finest of the BLANCO stainless steel finishes and has a warm undertone. The tone of the surface stays the same even if a hot pot is placed on the sink or if the sun shines on it for a long time. Reddish spots that appear on the surface are rust transferred from other rusting objects or from water pipes.
Care of the stainless steel sink
For daily cleaning, put a little washing-up liquid on the soft side of a sponge and wipe the surface in the direction of the grain, not with circular movements. Then rinse the sink and dry it with a microfibre cloth. To remove limescale, vinegar essence diluted with water in a ratio of 1:10, or a limescale remover, is suitable. A deep clean once a month is recommended with a stainless steel cleaner: apply a hazelnut-sized amount to the surface with a sponge and polish in the direction of the grain.
Do not use abrasive cleaning products or cleaners with hypochlorite bleach, silver cleaning baths, scratching sponges or steel wool on the surface of the sink. Products containing chlorine or hydrochloric acid and strong salt solutions left for a long time damage the surface. To clean the basket strainer, put a level teaspoon of dishwasher powder on the closed strainer, pour about 250 ml of boiling water over it, let it work, brush and rinse with clean water.
Included
- Undermount kitchen sink BLANCO ANDANO 340/340-U
- Drain and overflow set with space-saving pipe
- Two 3½″ InFino basket strainers
- Fixing set
Needed separately
One waste trap is needed to connect the sink to the sewer. The Waste trap for kitchen sink BLANCO 137267 has a 1½″ connection, its outlet fits a Ø40 or Ø50 mm sewer pipe and it has a dishwasher connection. If a waste sorting bin is to be fitted in the sink cabinet, the flat waste trap BLANCO 137287, which has a Ø50 mm outlet and a connection for two appliances, is suitable instead. The kitchen mixer tap must also be chosen separately.






Reviews
There are no reviews yet.