Description
Roller mop robot vacuum with a bagless station
The station of this roller mop robot vacuum collects dust in a bagless container, which you take off the station and empty with its release switch. The station’s solution compartment holds two boxes: the blue one for standard and the black one for strong cleaning solution, which the station uses to wash the roller mop after cleaning. The station refills the robot’s water tank itself.
OZMO ROLLER 2.0 roller mop and ZeroTangle 3.0 brushes
The high-density nylon roller mop turns at 200 rpm and receives clean water continuously while cleaning. Along walls TruEdge 3.0 extends the roller by 1.5 cm and the side brush collects debris from the edges. The robot quickly re-mops a light stain; for a heavier one it crosses the spot twice and washes the roller mop with strong solution. The robot detects carpet with 300 kHz ultrasound and then lifts the mop automatically. The ZeroTangle 3.0 ARClean side brush and the Triple-V main brush with its spiral comb keep hair from winding around the brushes.
Navigation, voice commands and battery
The robot maps rooms with dToF LiDAR up to 10 m away, and the AIVI 3D 3.0 camera and an infrared sensor detect obstacles. In the ECOVACS HOME app you can manage maps of several floors and set virtual boundaries; the robot works on a 2.4 GHz or mixed 2.4/5 GHz network and is set up over Bluetooth. Its microphone picks up voice commands from up to 5 m. The battery holds 6400 mAh and a full charge takes about 4 hours; with PowerBoost the robot first fast-charges for about 5 minutes after returning to the station. The robot is 9.8 cm high.
Installation and use
Remove the protective materials and attach the base to the station until it clicks. Place the station on a flat, hard surface against a wall with 0.05 m of free space at the sides and 0.8 m in front, and wind the excess power cord into the cable slot at the back. Cover the lowest 14 cm of mirrors and reflective strips near the station. Switch on the power switch under the robot’s top cover, fill the clean water tank and let the robot charge fully in the station before the first clean. Roll up carpets with a pile over 10 mm before cleaning or mark them as a no-go zone in the app.
Cleaning and maintenance
Rinse the robot’s dust box and filter with water once a week and let them air-dry; replace the filter every 3–6 months. Clean the main brush weekly and replace it every 6–12 months, clean the side brush every 2 weeks and replace it every 3–6 months, and replace the roller mop every 1–2 months. Wipe the sensors, charging contacts, navigation module and AIVI camera about once a month with a clean, dry cloth.
In the box
- DEEBOT robot vacuum
- OmniCyclone station
- Base
- Power cord
- User manual
- Pair of corner guards












Reviews
There are no reviews yet.