Description
Inset stainless steel sink BLANCO LEMIS 6-IF
The inset stainless steel sink BLANCO LEMIS 6-IF is set into the worktop cut-out from above, so its rim rests on the worktop. Its flat IF rim also allows flush mounting, with the rim level with the worktop. It has one bowl without a drainer; the outer size is 615 × 500 mm and the height 214 mm. The tap sits on a 95 mm deep area along the back of the sink, which has a factory-made tap hole.
Installation on or flush with the worktop
For inset mounting, the worktop cut-out is 595 × 480 mm with a tolerance of +2/−1 mm and a corner radius of 15 mm. Mounted this way, the sink suits almost any worktop: laminate and compact laminate, stone, glass, stainless steel and composites. The flat rim then sits almost level with the worktop. The rim is sealed with silicone, and the clamps are clicked in and tightened with a PZ2 bit in a crosswise order.
For flush mounting, a 617 × 502 mm rebate with a 26 mm corner radius and a tolerance of +1/−1 mm is also milled into the worktop; a 1 mm joint remains between the rim and the worktop. Only a water-repellent worktop suits this, such as granite, glass, artificial stone or mineral material, because wood and laminate swell in contact with water. BLANCO recommends having a flush sink fitted by a specialist. The drain outlet sits 322 mm below the worktop surface.
Bowl, drain and overflow
The bowl has a 60 mm corner radius. It drains through a 3½″ basket strainer that is opened and closed by hand. The waste and overflow kit has a space-saving pipe that leads the drain towards the back of the cabinet and leaves more room under the sink. BLANCO recommends this pipe when a pull-out waste sorter is fitted under the sink.
Stainless steel and surface finish
The sink is made of 18/10 stainless steel with 18% chromium and 10% nickel. With oxygen, chromium forms a thin invisible protective layer on the surface that renews itself. Fine scratches on a new sink are normal and become less visible as the layer renews.
The surface has a brushed finish. Hot pots and long sunlight do not dull or discolour it. Reddish spots come from other rusty objects or particles from the water pipes and wipe off.
Stainless steel sink care
For daily cleaning, put a little washing-up liquid on the soft side of a sponge and clean along the grain. Circular movements can permanently change a brushed surface. Then rinse the sink and dry it with a microfibre cloth. For limescale, use vinegar essence diluted 1:10 with water or BLANCO DailyClean+ (526305).
Once a month, clean the sink thoroughly: apply a hazelnut-sized amount of BLANCO DeepClean Stainless Steel (526306) with a sponge and polish along the grain. To clean the basket strainer, put a level teaspoon of dishwasher powder on the closed strainer, pour about 250 ml of boiling water over it, let it work and brush it clean. Keep abrasive cleaners, hypochlorite bleach, silver cleaning baths, cleaners with chlorine or hydrochloric acid, scratchy sponges and steel wool away from the sink.
In the box
- Waste and overflow kit with space-saving pipe
- 3½″ basket strainer, opened by hand
Needed separately
One trap is needed to connect the sink to the drain. The BLANCO 137267 trap connects the waste kit to a Ø40 or Ø50 mm drain pipe and has a dishwasher connection. With a waste sorter in the cabinet, the flat BLANCO 137287 trap fits, with a Ø50 mm outlet and two appliance connections. The kitchen tap is also bought separately.






Reviews
There are no reviews yet.