Description
Kitchen mixer tap with pull-out spray BLANCO CANDOR-S
The kitchen mixer tap with pull-out spray BLANCO CANDOR-S is a single-lever tap whose body and spout are solid stainless steel. The finish is brushed stainless steel. The high arched spout leaves room in the sink for filling pots and vases. The lever sits on the right and stands upright when closed, so the tap can also be fitted close to a back wall.
Spout, spray and flow
The total height is 368 mm and the spout reach 195 mm. The spray is concealed in the end of the spout, and a rear guide pin keeps it in position. The pull-out hose is nylon-coated, and a hose weight pulls the spray back into the spout after use. The maximum flow at 3 bar is 8 l/min. Water comes out as an aerated jet, and BLANCO’s aerator collects less limescale.
Installation and water pressure
The BLANCO CANDOR-S fits a 35 mm hole in the sink or worktop, and the mounting surface may be up to 50 mm thick. The flexible connection hoses are 700 mm long and connect with a ⅜″ nut to the cold and hot water angle valves under the sink. When fitted to a stainless steel sink, the stabilising plate gives the tap firmer support. A high-pressure tap (HD) suits a kitchen where both cold and hot water come from pipes in the wall; an open water heater under the sink needs a low-pressure tap (ND). The tap works at a water pressure of 1–10 bar with hot water up to 70 °C. Flush the water pipes before connecting the hoses, then unscrew the aerator, let water run for at least 20 seconds and check the connections.
Tap care
After use, dry the tap with a microfibre cloth, for example BLANCO cloth 126999. To remove limescale, use a vinegar or citric acid solution or BLANCO DailyClean+ (526305): spray it on, leave it for a moment, wipe with a damp cloth and dry. Unscrew a hard aerator anticlockwise and leave it overnight in vinegar water or citric acid solution. Clean with the soft side of a sponge and a chlorine-free cleaner. With old water pipes, BLANCO recommends fitting a dirt filter between the angle valve and the connection hose. BLANCO states that spare parts for its taps are available for at least 10 years.
In the box
- Hose weight that pulls the spray hose back
- Flexible connection hoses, 700 mm, with ⅜″ nut
- Stabilising plate for fitting the tap to a stainless steel sink
- Non-return valve (EN 1717)
Needed separately
Connecting the tap to the water supply needs cold and hot water angle valves under the sink.






Reviews
There are no reviews yet.