Description
Soldering iron with USB-C power and a colour display for electronics work
The FNIRSI HS-02B soldering iron with case works at up to 100 W, takes power through its USB-C port and lets you set the tip temperature from 100 to 450 °C. The 0.96-inch IPS colour display shows the actual and set tip temperature, the presets, the working voltage and the heating power. The iron is intended for soldering PCBs, SMD components and jewellery.

Three temperature presets and calibration
For frequent jobs the iron has three temperature presets, initially 300, 330 and 360 °C, and a short press of the OK button switches between them. Each button press changes the temperature in steps of 1–50 °C, and the reading can be shown in Celsius or Fahrenheit. The tip temperature can be calibrated against a thermometer at three points. The iron sounds a signal when the set temperature is reached.

Power from a USB-C PD or QC adapter
The iron works at 9–20 V and supports the PD and QC fast-charging protocols. From a PD adapter it can draw 9, 12, 15 or 20 V. To work with a smaller adapter, the maximum heating power can be limited to 10–100%, initially 65%.
Sleep and standby modes
When left idle, the iron enters sleep mode after a set delay of 1–60 minutes at a sleep temperature of 100–200 °C. Moving the handle wakes the iron, as does pressing any button. Standby switches the heating off, and a short press of OK resumes work.
Use
Push the tip into the iron, turning it slightly if needed, and connect the USB-C power cable; the iron then enters standby. A short press of OK starts heating and a long press stops it. The left- or right-hand mode swaps the plus and minus buttons. The firmware is updated over the USB-C cable: the computer sees the iron as a USB drive and you copy the firmware file onto it.

Tip care
Heat a new tip to 250 °C before the first use and coat it with solder. After work, leave a layer of solder on the tip, which protects the tip from oxidation. The normal working temperature of the tip is 300–380 °C, the sponge should be damp, not wet, and the flux low in chlorine and acid. Clean an oxidised tip with gauze, heat it to 250 °C and coat it with solder at once.
In the box
- Soldering iron FNIRSI HS-02B, 1 pc
- I, IS and K tips
- Soldering iron stand
- Lead-free solder wire, 42 g
- Cleaning kit
- Soldering tool set
- Adapter cable
- Storage case for the whole kit
- User manual





Reviews
There are no reviews yet.