Description
LCR meter in tweezer form for measuring electronic components
The FNIRSI LCR-ST2Plus LCR meter measures resistance from 10 mΩ to 10 MΩ, capacitance from 1 pF to 22 mF, inductance from 1 µH to 10 H and voltage up to ±30 V. It also checks diodes with a forward voltage up to 0.7 V and shows the secondary parameters ESR, X, D, Q, Z and θ.

Five test frequencies and four test levels
You can choose a test frequency of 100 Hz, 120 Hz, 1 kHz, 10 kHz or 100 kHz and a test level of 0.1, 0.3, 0.6 or 1 V. Dual-model mode shows series and parallel values together. Accuracy is up to 0.5% ±3 digits at 1 kHz and 10 kHz.


Frequency sweep and component sorting
Sweep mode measures a component across the whole range in one go, from 100 Hz to 100 kHz. In sorting mode you set the nominal value and tolerance, and the screen marks a passing part green and a failing one red, counting both.

Probes and use
The straight and curved tweezer tips are for small SMD components. For larger and through-hole parts you plug the Kelvin clip lead into the USB port; it measures with the four-wire method. Auto mode identifies resistors, capacitors and inductors by itself. A long press of the power button switches it on, the thumb wheel selects the function and a short press of the power button holds the reading (HOLD).


Display, battery and settings
The 1.47-inch colour display rotates for right- or left-handed use and the body has a magnetic mount. The 300 mAh battery gives about 3 hours of use and charges over USB-C; the same port is used for firmware updates. In the settings you choose measurement speed, brightness, auto power-off after 5, 15 or 30 minutes and calibration with short, open circuit or reference resistors.
In the box
- LCR meter FNIRSI LCR-ST2Plus, 1 pc
- Storage case
- Curved probe
- Shorting plate
- Data cable
- Kelvin clip lead
- User manual




Reviews
There are no reviews yet.