Description
Signal generator with two independent channels for electronics testing
The two-channel FNIRSI TSG6020 signal generator produces sine signals up to 60 MHz. The signal is generated by direct digital synthesis (DDS) at a sampling rate of 200 MSa/s with 14-bit vertical resolution.

Output voltage, load and channel protection
Into a high-impedance load each channel delivers 2 mVpp–20 Vpp up to 10 MHz and up to 10 Vpp above that; into 50 Ω it delivers 1 mVpp–10 Vpp and up to 5 Vpp respectively. The load can be set to 50 Ω, high impedance or 1–9999 Ω, and amplitude limiting protects the connected circuit. The start phase of the channels can be independent or synchronised. If a voltage above the permitted level reaches the output, overvoltage protection switches the output off automatically.

Waveforms, modulation and arbitrary waveform generator
Square and pulse waves go up to 24 MHz and ramp waves up to 20 MHz, and noise and DC are also available. The non-volatile memory holds 24 built-in arbitrary waveforms, such as cardiac, EEG and radar pulse, which can be output at up to 10 MHz or point by point at up to 200 MSa/s. Modulation types are AM, FM, PM, ASK, PSK and FSK, and the keying modulations can also be driven by an external TTL signal. Linear and logarithmic frequency sweeps last from 1 ms to 500 s.
Built-in 7-digit frequency counter
Through the FSK/CNT/Sync connector the generator measures the frequency, period and duty cycle of TTL-level signals from 100 mHz to 100 MHz with ±51 ppm accuracy.

Touchscreen and numeric keypad
Parameters can be entered on the 4.3-inch TFT touchscreen with 480 × 272 resolution or with the numeric keypad and rotary knob. The screen can be tilted up to 90° with the side knobs.

Power and connections
The rear panel has a 5 V / 2 A USB-C power input and a USB port for connecting to a computer, and the generator’s power consumption is below 10 W. The front panel has BNC outputs for CH1 and CH2 and the FSK/CNT/Sync connector.

Use
After switching on, the generator outputs a 1 kHz, 100 mVpp sine signal. To change the frequency, tap the waveform area on the screen or press Wave, choose sine and frequency, enter the value on the keypad and select the unit on screen. The output is switched on with the CH1 or CH2 key, and the key backlight shows that the output is on.
Cleaning and care
Before cleaning, disconnect the power and wipe the housing with a damp but not dripping soft cloth, using water or a mild detergent. Do not use substances containing benzene, toluene, xylene or acetone, and take care not to scratch the LCD protective screen. Let the device dry completely before switching it on again.
In the box
- Signal generator FNIRSI TSG6020, 1 pc
- power adapter 5 V / 2 A
- BNC cable, 1 m
- BNC to crocodile clip cable


Reviews
There are no reviews yet.