Description
Kitchen tap with pull-out spray BLANCO MIDA-S
The kitchen tap with pull-out spray BLANCO MIDA-S is a single-lever tap whose arched spout rises from a slender, straight body. The colour is volcano grey and the lever sits on the right side of the body. As a high-pressure tap (HD), MIDA-S is connected to cold and hot water pipes coming from the wall.
Spout, spray and flow rate
The spout reach is 186 mm and the total height 336 mm. The maximum flow rate at 3 bar is 10 l/min, and the aerator at the end of the spray mixes air into the jet. The pull-out spray is plastic and the spray hose is nylon-sheathed. A hose weight returns the spray reliably to the spout.
Installation and water pressure
The tap fits a 35 mm tap hole and the mounting surface may be up to 53 mm thick. It is connected with flexible connection hoses, 500 mm long with a ⅜″ nut. Before connecting the hoses, flush the pipes by letting water run from the angle valves into a bucket.
In a stainless steel sink, a stabilisation plate gives the tap extra support. A non-return valve prevents backflow into the pipework in accordance with EN 1717. After connecting, unscrew the spray aerator, run water for at least 20 seconds and check every connection for leaks. For old water pipes, BLANCO recommends fitting a dirt filter between the angle valve and the connection hose.
According to BLANCO’s instructions, the supply pressure may be up to 10 bar, and the planning note asks for at least 2 bar. A high-pressure tap (HD) is meant for a kitchen where cold and hot water pipes come from the wall. Where an open boiler under the sink supplies hot water, a low-pressure tap (ND) with three connection hoses is the right choice. Because the number of hoses differs, a high-pressure tap is always connected to high-pressure connections.
Finish and sink colour
The tap body is brass with a volcano grey SILGRANIT-look surface. BLANCO makes its SILGRANIT-look taps in the colours of its SILGRANIT sinks, so the volcano grey MIDA-S matches a BLANCO sink in the same colour.
Tap care
After use, dry the tap with a microfibre cloth. To remove limescale, use a vinegar or citric acid solution or a descaler: leave it only for the time its instructions allow, then rinse the tap with water. Do not clean the tap with chlorine-based cleaners.
If the aerator is hard with limescale, unscrew it anticlockwise and leave it overnight in vinegar water or citric acid. According to BLANCO, spare parts for the tap are available for at least 10 years.
In the box
- Kitchen mixer tap BLANCO MIDA-S, 1 pc
- Flexible connection hoses, 500 mm, with ⅜″ nut
- Stabilisation plate for fitting the tap in a stainless steel sink
- Hose weight that pulls the spray hose back
- Non-return valve (EN 1717)




Reviews
There are no reviews yet.