Description
BLANCO LANORA kitchen mixer tap with high spout
The kitchen mixer tap with high spout BLANCO LANORA is a single-handle mixer with straight-lined shapes, whose body, spout and handle are made of brushed stainless steel in a matching finish. The handle is on the right side of the body and is used to set both the flow rate and the mix of cold and hot water. When the mixer is closed, the handle stands upright, so the mixer can also be installed close to the back wall. In the middle position of the handle, cold water comes from the spout.
Spout, water jet and flow rate
The spout reaches 220 mm from the centre of the body and the total height of the mixer is 296 mm. At a water supply pressure of 3 bar, the mixer delivers 10.7 litres of water per minute. There is an aerator at the end of the spout that mixes air into the water jet, and according to BLANCO, less limescale builds up on it thanks to its design.
Installation and water pressure
The mixer is installed in a 35 mm diameter hole in the sink or worktop, and the thickness of the mounting surface can be up to 50 mm. On a stainless steel sink, a stabilising plate holds the mixer firmly in place. The flexible connection hoses are 700 mm long with a ⅜″ nut, and they are connected to the cold and hot water angle valves.
Close the angle valves before connecting the hoses. After connecting, unscrew the aerator with a 17 mm spanner, let the water run for at least 20 seconds, put the aerator back and check that the connections are dry. BLANCO recommends having the mixer installed by a specialist.
The mixer works at a water supply pressure of up to 10 bar and a hot water temperature of up to 70 °C. The high-pressure mixer is intended for a kitchen where both cold and hot water come from pipes in the wall. For an open boiler located under the sink, a low-pressure mixer (ND) with three hoses is needed. Only a low-pressure mixer is suitable to replace a low-pressure mixer, because the number of hoses is different.
Finish and material
The mixer is made entirely of stainless steel and its surface is brushed. The end of the handle has circular brushing marks.
Mixer care
After use, dry the mixer with a microfibre cloth. To remove limescale, use a vinegar or citric acid solution or a limescale remover: spray it on the surface, let it work for a moment, wipe with a damp cloth and dry. Clean with the soft side of a sponge and do not use cleaning agents containing chlorine.
If the jet starts to splash, limescale has built up in the aerator. Unscrew the aerator and leave it overnight in vinegar water or a citric acid solution. According to BLANCO, spare parts for the mixers are available for at least 10 years.
Included
- BLANCO LANORA kitchen mixer tap
- Flexible connection hoses, 700 mm, with ⅜″ nut
- Stabilising plate for installing the mixer in a stainless steel sink
Needed separately
To connect the mixer to the water mains, cold and hot water angle valves are needed under the sink. With old water pipes, BLANCO recommends installing a dirt filter between the angle valve and the connection hose, and in the case of high pressure, two filters in a row.





Reviews
There are no reviews yet.