Description
BLANCO MILI kitchen mixer tap with J-shaped spout
The kitchen mixer tap with J-shaped spout BLANCO MILI is a slim single-lever mixer whose body and J-shaped spout are in the colour anthracite. The lever is on the right side of the body and it sets both the flow rate and the mix of cold and hot water. The lever moves 67.5 mm to either side from the central position.
Spout, water jet and flow rate
The spout reaches 210 mm from the centre of the body and the total height of the mixer is 313.5 mm. At a water supply pressure of 3 bar the mixer delivers 15 litres of water per minute. There is an aerator at the end of the spout that mixes air into the water jet, and according to BLANCO less limescale collects on it thanks to its construction.
Installation and water pressure
The mixer is installed in a hole with a diameter of 35 mm in the sink or worktop and the thickness of the mounting surface can be up to 60 mm. On a stainless steel sink, a stabilising plate holds the mixer firmly in place. The flexible connection hoses are 500 mm long with a ⅜″ nut and they are connected to the cold and hot water angle valves.
Close the angle valves before connecting the hoses. After connecting, unscrew the aerator from the end of the spout, let the water run for at least 20 seconds, screw the aerator back on and check that the connections are dry. BLANCO recommends having the mixer installed by a professional.
The mixer works at a water supply pressure of up to 10 bar and a hot water temperature of up to 70 °C. The high-pressure mixer is intended for a kitchen where both cold and hot water come from pipes in the wall. For an open boiler located under the sink, a low-pressure (LP) mixer with three hoses is needed. Only a low-pressure mixer is suitable to replace a low-pressure mixer, because the number of hoses is different.
Finish and sink colour
The body of the mixer is made of brass and its surface has a SILGRANIT-look finish. The colour follows the colours of BLANCO SILGRANIT sinks, so the anthracite mixer is the same colour as an anthracite BLANCO sink.
Mixer care
After use, dry the mixer with a microfibre cloth. To remove limescale, use a vinegar or citric acid solution or a limescale remover: spray it on the surface, leave it to work for a moment, wipe over with a damp cloth and dry. Clean with the soft side of a sponge and do not use cleaning agents containing chlorine or deep cleaners for sinks.
If the jet starts to splash, limescale has built up in the aerator. Unscrew the aerator anticlockwise and leave it overnight in vinegar water or a citric acid solution. According to BLANCO, spare parts for the mixers are available for at least 10 years.
Included
- BLANCO MILI kitchen mixer tap
- Flexible connection hoses, 500 mm, with ⅜″ nut
- Stabilising plate for installing the mixer in a stainless steel sink
Required separately
To connect the mixer to the water supply, cold and hot water angle valves are needed under the sink. With old water pipes, BLANCO recommends installing a dirt filter between the angle valve and the connection hose, and two filters in a row in the case of high pressure.




Reviews
There are no reviews yet.