Description
Kitchen tap with high J-shaped spout BLANCO MILI
The kitchen tap with high J-shaped spout BLANCO MILI mixes cold and warm water with a single lever on the right side of its cylindrical body. The colour is black. A high-pressure tap suits kitchens where both cold and hot water pipes come out of the wall; an open, unvented boiler under the sink needs a low-pressure tap (ND).
Spout and flow
The spout reach is 210 mm and the overall width 245 mm. The end of the lever sits 146 mm above the worktop. The maximum flow is 15 l/min at 3 bar.
An aerator at the end of the spout adds air to the jet. According to BLANCO, the aerator is a patented design that collects less limescale.
Installation and water pressure
The tap fits a 35 mm hole in the sink or worktop, with a mounting surface up to 60 mm thick. The base is 45 mm in diameter. The flexible connection hoses are 500 mm long with a ⅜″ nut. Installation needs 9 mm and 19 mm spanners, pipe pliers and a screwdriver.
The tap is fixed from below with a fixing plate and nuts, tightened with the 9 mm spanner. In a stainless steel sink the supplied stabilising plate gives the tap extra support. Before connecting the hoses, flush the pipes: open the angle valves and let the water run into a bucket.
After installation, unscrew the aerator, run the water for at least 20 seconds and refit the aerator. Then check that all connections are dry. For old pipes BLANCO recommends a dirt filter between the angle valve and the tap hose.
The tap withstands mains pressure up to 10 bar and hot water up to 70 °C. A high-pressure tap connects directly to the cold and hot water pipes. A low-pressure tap for an open boiler uses three hoses, so a high-pressure tap is installed only on a high-pressure connection.
Finish and matching sink colour
The body is brass with a black SILGRANIT-look finish. BLANCO matches the colours of its SILGRANIT-look taps to its SILGRANIT sinks, so the black tap matches a black BLANCO sink.
Tap care
Dry the tap with a microfibre cloth after use. Limescale can be removed with a vinegar or citric acid solution or a descaler; then rinse the tap with clean water and dry it. Clean the surface with a soft cloth, as chlorine-based cleaners and the scouring side of a sponge damage the finish.
To clean the aerator, unscrew it anticlockwise and leave it overnight in vinegar water or citric acid solution. BLANCO states that spare parts for its taps are available for at least 10 years.
In the box
- Kitchen mixer tap BLANCO MILI, 1 pc
- Flexible connection hoses, 500 mm, with ⅜″ nut
- Stabilising plate for installation in a stainless steel sink




Reviews
There are no reviews yet.