Description
Kitchen mixer tap with J-shaped spout BLANCO MILI
The kitchen mixer tap with J-shaped spout BLANCO MILI is a single-lever tap: the lever on the right of the body sets the flow and the temperature. The body is brass with a black matt finish.
Spout reach and flow
The tap is 313.5 mm high in total and the fixed spout reaches 210 mm. The flow at 3 bar is up to 15 l/min. The aerator screwed into the spout tip mixes air into the water, which runs as a soft aerated jet.
Installation and water pressure
The tap fits a 35 mm hole in the sink or worktop, and the mounting surface may be up to 60 mm thick. The base diameter is 45 mm. The flexible connection hoses in the box are 500 mm long with a ⅜″ nut. In a stainless steel sink, put the stabilising plate under the tap for firmer support.
A high-pressure tap fits when the kitchen has both a cold and a hot water wall valve and the water is heated centrally or by an instantaneous water heater. An open boiler under the sink needs a low-pressure tap (ND) with three hoses. A high-pressure tap connects only to a pressurised supply, because its number of hoses differs from a low-pressure tap. The tap withstands water pressure up to 10 bar and hot water up to 70 °C.
The tap is fixed from below with the nuts of two threaded rods, tightened with a 9 mm spanner. Before connecting the hoses, flush the pipes by opening the angle valves over a bucket, then connect the hoses with a 19 mm spanner. Finally unscrew the aerator by hand, let the water run for at least 20 seconds, refit the aerator and check the joints for leaks.
Tap care
Dry the tap with a microfibre cloth after use. To remove limescale, use a vinegar- or citric-acid-based descaler and keep to its contact time. Chlorine cleaners and the rough side of a sponge damage the matt finish, so clean the tap with a soft cloth or sponge.
A hard aerator can be unscrewed anticlockwise and put overnight in vinegar water or citric acid. BLANCO states that spare parts for its taps are available for at least 10 years.
In the box
- Kitchen mixer tap BLANCO MILI, 1 pc
- Flexible connection hoses, 500 mm, with ⅜″ nut
- Stabilising plate for installing the tap in a stainless steel sink
Needed separately
To connect the hoses you need cold and hot water angle valves under the sink. For old pipes BLANCO recommends a dirt filter between the angle valve and the connection hose.




Reviews
There are no reviews yet.