Description
Undermount stainless steel sink BLANCO ETAGON 500-U
The undermount stainless steel sink BLANCO ETAGON 500-U is fixed from below into the worktop cut-out, so the sink rim sits below the worktop. The surface has a satin polish finish, the outer size is 540 × 440 mm and the height is 199 mm.
The sink has one stepped bowl. The step moulded into the bowl wall creates a second working level on which the ETAGON rails rest.
Undermount installation
The sink suits a dense, water-resistant worktop such as natural stone, composite or glass; it does not suit wood or wood-based boards. The worktop cut-out is 500 × 400 mm with a tolerance of +2/−1 mm and a corner radius of 35 mm.
The sink is fixed at four points with the supplied fixing kit: holes of 5 mm diameter and 15 mm depth are drilled into the underside of the worktop 27 mm from the cut-out edge, and the fixings are screwed on with a PZ 2 screwdriver. Silicone is applied to the sink rim before fixing to seal the joint between sink and worktop. The tap is fitted into the worktop: the hole is 35 mm in diameter and drilled 60 mm from the edge of the cut-out.
Bowl, waste and overflow
The waste outlet holds a 3½″ InFino basket strainer that is opened and closed by hand. The overflow is covered (C-overflow) and integrated into the bowl wall.
The waste kit has a space-saving pipe that routes the waste towards the back of the cabinet and leaves more room under the sink. BLANCO recommends this kit when a pull-out waste sorter goes under the sink.
Stainless steel and surface finish
The sink is made of 18/10 stainless steel, which contains 18% chromium and 10% nickel. With oxygen, the chromium forms a thin, invisible protective layer on the surface that renews itself. The first fine scratches on a new sink are normal, and many of them become less visible within a few days as the layer renews.
The satin polish surface has a warm undertone. Its colour stays the same when a hot pot is put on the sink or the sun shines on it for a long time. Reddish spots on the surface are rust carried over from other rusty objects or the water pipes and wipe off.
Stainless steel sink care
For daily cleaning put a little washing-up liquid on the soft side of a sponge and clean along the brushing lines, not in circles, because circular movements change the structure of the satin surface. Then rinse the sink and dry it with a microfibre cloth.
To remove limescale use vinegar essence diluted 1:10 with water, or a descaler. Once a month clean the sink thoroughly with a stainless steel cleaner: put a hazelnut-sized amount on a sponge and rub along the brushing lines.
To clean the basket strainer, put one level teaspoon of dishwasher powder on the closed strainer and pour about 250 ml of boiling water over it. Let it work, brush and rinse with clean water.
Do not use abrasive cleaners, hypochlorite bleach, silver cleaning baths, prickly brushes, the scouring side of a sponge, steel wool, cleaners containing chlorine or hydrochloric acid, or strong salt solutions left to act for a long time.
In the box
- Kitchen sink BLANCO ETAGON 500-U, 1 pc
- 2 stainless steel ETAGON rails
- Waste and overflow set with space-saving pipe
- 3½″ InFino basket strainer
- Fixing kit
Needed separately
One trap is needed to connect the sink to the drain. Kitchen sink trap BLANCO 137267 connects the waste kit to a Ø40 or Ø50 mm drain pipe and has a dishwasher connection. With a waste sorter under the sink, the flat kitchen sink trap BLANCO 137287 fits, with a Ø50 mm outlet and two appliance connections. The kitchen tap is also bought separately.





Reviews
There are no reviews yet.