Description
Inset stainless steel sink BLANCO CLARON 550-IF
The inset stainless steel sink BLANCO CLARON 550-IF sits in the worktop cut-out with its flat IF rim resting on the worktop. The same sink can also be flush-mounted, with the rim level with the worktop. The surface has a satin polish finish and the outer size is 590 × 440 mm, height 199 mm. The bowl corners have a 10 mm radius, so the full bowl volume is usable.
Installing on or flush with the worktop
Installed from above, the flat IF rim fits any common worktop, laminate included: stone, glass, stainless steel and composite as well. The cut-out is 580 × 430 mm with a tolerance of +2/−1 mm and a corner radius of 0–15 mm. The joint between the rim and the worktop is sealed with silicone and the sink is fixed from below with the clamps of the kit.
Flush mounting needs a water-repellent worktop such as granite, glass, artificial stone or mineral material. A 592 × 442 mm rebate, 1.5–2 mm deep with an 11 mm corner radius, is milled round the cut-out, leaving a 1 mm gap between rim and worktop. BLANCO recommends having a flush sink fitted by a specialist.
The sink has no tap ledge; the tap goes into a 35 mm hole in the worktop. In a laminate worktop a flexible sealing tape is needed round the tap hole.
Bowl, waste and overflow
The waste has a hand-operated 3½″ InFino basket strainer and a covered C-overflow. The waste and overflow set has a space-saving pipe that runs the waste towards the back of the cabinet and leaves room under the sink. BLANCO recommends this pipe when a pull-out waste sorter goes into the sink cabinet.
Stainless steel and surface finish
The sink is made of 18/10 stainless steel, which contains 18% chromium and 10% nickel. With oxygen, the chromium forms a thin invisible protective layer that renews itself. The first fine scratches on a new sink are normal and become less visible within a few days as the layer renews. Reddish spots on the satin surface are rust carried over from other rusty objects or the water pipes and wipe off.
Stainless sink care
After each use wipe the sink with a soft cloth and a mild cleaner and rub it dry, so no limescale spots remain. Small spots are usually limescale and come off with a damp cloth. For stubborn limescale use a descaling stainless steel cleaner with a suitable sponge.
To clean the basket strainer, put a level teaspoon of dishwasher powder on the closed strainer, pour about 250 ml of boiling water over it and leave it to act. Then brush the strainer clean and rinse. Gentle products keep the surface in good condition, as the scouring side of a sponge, steel wool, scrapers, cleaners with chlorine or hydrochloric acid and strong salt solutions left for long damage it.
In the box
- Kitchen sink BLANCO CLARON 550-IF, 1 pc
- Waste and overflow set with space-saving pipe
- 3½″ InFino basket strainer
- Fixing kit
Needed separately
One trap is needed to connect the sink to the drain. Kitchen sink trap BLANCO 137267 connects the waste set to a Ø40 or Ø50 mm drain pipe and has a dishwasher connection. The kitchen tap is also bought separately.





Reviews
There are no reviews yet.