Description
Window cleaning robot with a pad-washing, self-cleaning station
The corded and cordless window cleaning robot ECOVACS WINBOT W3 OMNI runs from the mains or from the station’s battery pack, so a socket does not need to be near the window. The station washes the cleaning pad with the Vortex Wash system: 16 high-pressure nozzles spray water at 20 kPa, 4 scrubbers turn at 200 rpm and a wiper removes the dirty water; according to the manufacturer, a wash takes about a minute.
Station water tanks, display and cable
The station has a clean water tank of about 1.2 l, a dirty water tank and two pad washing modes: standard wash and intensive wash. After the robot finishes, the station starts self-cleaning, and the dirt collects in a sealed tray and drains to the dirty water tank. With the display and touch buttons you choose fast, deep or edge cleaning for the glass, send the robot to its starting point and wind the 5.5 m composite cable back into the station. The battery pack charges in about 3 hours at room temperature.
Spraying, edges and cleaning modes
Three wide-angle spray nozzles moisten the glass, and the robot’s 80 ml tank covers about 55 m². Near the window edge the TruEdge scrubber lowers, turns at 200 rpm and lifts after cleaning. The app adds zone, spot, thorough and heavy-duty cleaning; WIN-SLAM 5.0 plans the cleaning path and, according to the manufacturer, the robot moves at up to 16 cm/s.
Control with the ECOVACS HOME app
The robot connects to the app over Bluetooth and Wi-Fi, and software updates also arrive over Wi-Fi. In the app you move the robot with 360° remote control, switch between indoor and outdoor window views and spray water manually.
Safety rope and fall protection
Before cleaning, lock the carabiner of the factory-fitted safety rope to a fixed object such as a table leg, bed leg or curtain rod. The three-layer composite cable has a tensile strength of up to 100 kg, the station base has an extra 1 m safety rope, and a suction cup holds the 10 kg station to the floor with over 800 N. The frameless glass sensor, air pressure sensor and IMU sensor monitor the edge, the suction and the robot’s position.
Use
Connect the battery pack to the plug under the station’s rear cover and place it in its slot, then set the station next to the window on a flat, smooth floor and lock the carabiner. Pour ECOVACS WINBOT cleaning solution into the robot tank and clean water into the station’s clean water tank, moisten the pad in the station with a standard wash and clip it under the robot with the four clips. Hold the station’s power button for 2 seconds and, when the fan starts, place the robot pad-side on the glass: it attaches itself and returns to its starting point at the end. A single window can be up to 8 m wide and 2.5 m high, and on frameless glass you attach the robot at least 10 cm from the edge.
Cleaning and maintenance
After use, empty the robot tank and the station’s clean and dirty water tanks and rinse the tanks clean. Replace a cleaning pad after 30 uses. Wipe the fan, side rollers and round sensors with a clean dry cloth.
In the box
- Window cleaning robot ECOVACS WINBOT W3 OMNI, 1 pc
- Station, 1 pc
- Battery pack, 1 pc
- Safety rope with carabiner
- AC power cord
- Power cord
- Cleaning pad
- ECOVACS WINBOT cleaning solution
- User manual












Reviews
There are no reviews yet.