Description
Aquarium surface filter with floating head
To clean the water surface, the aquarium surface filter combines three functions: aeration, removal of the oil layer and filtration. The floating head adjusts automatically to water level changes of up to 4 cm. The built-in filter sponge catches the collected dirt. The filter has a power of 5 W and a maximum lift height of 0.75 m.

Adjusting the suction head height and aeration
The working height of the suction head is changed with the regulator wheel on the housing, so that the suction head stays at a suitable height for removing the surface layer. The amount of air is adjusted by turning the air valve to the left or right. Aeration increases water movement at the surface and improves oxygen exchange.

Installation
Place the filter in the water so that the floating head is as close as possible to its upper position relative to the current water level: this leaves adjustment room even as the water evaporates. Attach the suction cups to the clean inside glass of the aquarium. Using the suction cups on the power cable, fix the cable to the inside wall of the aquarium away from the suction head, so that the cable does not interfere with removing the surface layer. Before connecting to the mains, check that the voltage matches the value marked on the product label.

Cleaning and maintenance
Before maintenance, disconnect the filter from the mains and remove the floating head. Take the filter sponge out with tweezers or a similar tool and clean it thoroughly. Put the sponge back flat and in the correct position, because in the wrong position the sponge filters less effectively.

Included in the package
- Surface filter (with floating head, filter sponge and back cover)
- Air regulator with plastic tube
- Suction cups


Reviews
There are no reviews yet.