Description
External aquarium filter for freshwater and saltwater aquariums
The SUNSUN HW-502 filter is an external aquarium filter that can be used in both freshwater and saltwater aquariums. The filter pump is located inside the housing.


Filter media and water flow in the filter
The housing contains four layers of filter media: a biochemical filter media at the top, and below it filter media with fine, medium and coarse pores. Water enters the filter from below and passes through the layers from coarsest to finest until it exits through the outlet opening. When adding other filter media, remove the corresponding number of filter layers according to that quantity.
Installation and connection
The inlet and outlet each have their own flow rate control valve. When installing the valves, check that the sealing ring of the valve base connector is correctly in place. Before first use, open the outlet valve, close the inlet valve, disconnect the suction hose and fill it with water, keeping the hose as straight as possible. Then reconnect the hose, tighten the nut and open the inlet valve: water flows into the filter by siphon effect until the water level is even in both hoses. Only then connect the filter to the mains.

Cleaning and maintenance
To open the lid, release the four clips, hold the housing with one hand and pull the lid up by the handle with the other hand. Clean the housing, rotor, hoses and filter media regularly. After putting the filter media back, press the lid firmly onto the housing so that they are exactly level, and secure the clips.

Included in the package
- HW-502 external filter with built-in pump
- Filter media: biochemical, fine, medium and coarse pore, and filter plate
- Inlet and outlet flow rate control valve
- Inlet section: suction pipe with intake strainer
- Outlet section: outlet pipe and water spray pipe
- Inlet and outlet hoses


Reviews
There are no reviews yet.