Description
External aquarium filter with a transparent body
In this external aquarium filter, which operates outside the aquarium, water flows from top to bottom through 5 successive filter zones. The body is transparent so that you can check how dirty the filter sponges are without taking the filter apart.

Filter sponges and biological filtration
Above the sponges there is room for nitrifying bacteria, which support the biological balance of the aquarium. The blue filter sponge then catches sediment, the yellow one fine particles and the black one colloidal residues. Finally, the white non-woven filter layer removes any remaining colouring from the water.


Installation and connection
To remove the lid, open the 4 locking clips, place the filter media in the body and fit the upper filter plate in the reverse direction. Attach the flow regulators to the lower connection of the filter and to the lid, tighten the screws and check that the sealing ring is in place. On first start-up, fill the filter with water to 75%, connect all parts according to the diagram and only then switch on the power. After switching on, the inlet regulator must be open.

Cleaning and maintenance
Before opening the lid, let the pump pump some of the water in the filter back into the aquarium. Then close the inlet control valve and switch off the power.
Included in the package
- HW-603B external filter with external pump
- Filter sponges: blue, yellow and black, and white filter layer
- 12 mm hose, 1.5 m, 2 pcs
- Shut-off valve with flow regulator, 2 pcs
- Intake pipe with protective cage
- Multi-hole water spray pipe
- Flat outlet nozzle
- Suction cups
- User manual



Reviews
There are no reviews yet.