Description
External aquarium filter for freshwater and saltwater aquariums
The SUNSUN HW-503 filter is an external aquarium filter that can be used in both freshwater and saltwater aquariums. The filter pump is located inside the housing.

Filter media and water flow in the filter
The housing contains four layers of filter media: the upper biochemical filter media and, below it, filter media with fine, medium and coarse pores. Water enters the filter from below and passes through the layers from coarsest to finest, until it exits through the outlet opening. If you add other filter media, remove the corresponding number of filter layers according to its quantity.
Installation and connection
The opening marked OUT on the lid is the outlet, and the opening on the bottom of the housing is the inlet. Both have their own flow rate control valve. When installing the valves, check that the sealing ring of the valve base connector is correctly in place. Before first use, close the outlet valve, close the inlet valve, disconnect the suction hose and fill it with water, keeping the hose as straight as possible. Then reconnect the hose, tighten the nut and open the inlet valve: water flows into the filter by siphon effect until the water level is even in both hoses. Only then connect the filter to the mains.

Cleaning and maintenance
To open the lid, release the four clips, hold the housing with one hand and pull the lid up by the handle with the other hand. Clean the housing, rotor, hoses and filter media regularly. After putting the filter media back, press the lid firmly onto the housing so that they are exactly level, and secure the clips.
Included in the package
- HW-503 external filter with built-in pump
- Filter media: biochemical, fine, medium and coarse pore, and filter plate
- Inlet and outlet flow rate control valve
- Hose
- Water spray pipe
- Inlet pipe with suction basket
- Corner connector (2 pcs)
- Suction cups



Reviews
There are no reviews yet.